1、 What is the mixer tug for?

攪拌車拖輪是個軸承，用于把罐體支撐起來，與攪拌車是一體的，輔助攪拌。

Mixer tug is a bearing, used to support the tank, and mixer is one, auxiliary mixing.

二、攪拌車液壓泵怎么換油？

2、 How to change oil for hydraulic pump of mixer truck?

一般不建議自己換，直接到售后點找技術人員更換，而且使用的油須符合要求，不然對設備損害很大，使用壽命也會大大縮短，更換合理標號的液壓油。

Generally, it is not recommended to replace it by yourself, but directly go to the after-sales point to find a technician to replace it, and the oil used must meet the requirements, otherwise it will cause great damage to the equipment and greatly shorten the service life, so it is necessary to replace the hydraulic oil with reasonable label.

三、攪拌車罐體填充率跟罐體傾角有什么關系？

3、 What is the relationship between the filling rate of mixer tank and the inclination angle of tank?

目前攪拌車傾角在12度左右，填充率為百分之63左右，傾角不好測量，填充率也很難計算。目前銷售的攪拌車都以攪拌容積為準。

At present, the inclination angle of the mixer is about 12 degrees, and the filling rate is about 63%. It is difficult to measure the inclination angle and calculate the filling rate. At present, the sales of mixer are subject to the mixing volume.

四、水泥自動攪拌車罐不轉，轉開了沒力而液壓油從郵箱加油口噴出來是什么原因？

4、 Concrete mixer tank does not turn, turn to open no force and hydraulic oil from the mailbox fuel spout out what is the reason?

液壓一個進一個回，進沒力可能是油泵封閉部分壞了。回油沖，可能是油泵封閉腳墊壞了。

The hydraulic pressure goes in and out one by one. If there is no force, the sealing part of the oil pump may be broken. The return oil is flushed. Maybe the sealing pad of the oil pump is broken.

五、攪拌車攪拌筒的轉速是多少？

5、 What is the rotational speed of mixer drum?

進料時攪拌筒的轉速是：6---10轉/分；攪拌時攪拌筒的轉速：6--10轉/分。

The rotation speed of the mixing drum during feeding is 6-10 rpm; the rotation speed of the mixing drum during mixing is 6-10 rpm.

六、8--12方的水泥自動攪拌車進料口到地面距離是多少？

6、 What is the distance between the feeding port of 8-12 cubic meters concrete mixer truck and the ground?

一般8--12方的攪拌車整車高度大概在3.8米左右，進料口距離地面就有3.5米左右，具體的根據不同的車型來定。

Generally, the height of 8-12 square mixer truck is about 3.8 meters, and the distance between the feed port and the ground is about 3.5 meters, which depends on different models.

七、水泥攪拌車怎么清洗罐？

7、 How to clean the tank of cement mixer?

攪拌車配的水箱，每次卸完料后就應該將水放入罐內，在返回時攪拌行使，到攪拌站后再將水排出接料。罐體外表應該在水箱加水時即可順便清洗。當然也可以直接用水箱內的水清洗。如果水泥漿已經凝固，罐體內找專門的清罐，外表凝固用草酸刷洗就行了。

The water tank equipped with the mixer truck should put the water into the tank after unloading each time. When it returns, it should be stirred and discharged to the mixing station. The surface of the tank should be cleaned when the water tank is filled with water. Of course, it can also be directly cleaned with water in the water tank. If the cement slurry has set, find a special cleaning tank inside the tank, and brush the surface with oxalic acid.

本文由自動攪拌車為您提供，我們的網站是：http://www.sansungmobile.cn我們將以全心全意的熱情為您提供服務，歡迎您的訪問！

Our website is: http://www.sansungmobile.cn We will serve you wholeheartedly and warmly. Welcome to visit!