Self loading cement mixer is used in rural construction, rural cement pavement, narrow construction site, etc. Many of our friends who buy the self feeding mixer will do some maintenance work regularly after using the self feeding mixer. On the one hand, it can avoid the influence of the self feeding mixer on its normal service life, and on the other hand, it can avoid the failure of the self feeding mixer after it is damaged.

（一）檢查好自上料攪拌車的供水系統

（1） Check the water supply system of self feeding mixer

檢查供水系統時，要檢查好水管跟接頭是否有漏水的現象，如果自上料攪拌車供水系統中的水管有松動或者老化的現象需要盡快去更換。

When checking the water supply system, it is necessary to check whether the water pipes and joints are leaking. If the water pipes in the self feeding mixer water supply system are loose or aging, they need to be replaced as soon as possible.

（二）檢查好攪拌桶有誤破損

（2） Check the mixing bucket for damage

檢查好自上料攪拌車的攪拌桶是否有破損、松動、工作聲音不正常等現象，每月定期做好潤滑。

Check whether the mixing drum of self feeding mixer is damaged, loose, abnormal working sound, etc., and lubricate regularly every month.

（三）自上料攪拌車的操作系統

（3） Operation system of self loading mixer

要注意好自上料攪拌車操作是否靈活正常，盡可能的保持每月做一次潤滑處理。避免后期使用出現問題。

Pay attention to whether the operation of self feeding mixer is flexible and normal, and try to keep lubrication treatment once a month. Avoid problems in later use.

在施工完畢后需要立即用自動上料攪拌車隨帶的軟管對準進料口跟出料口上面殘留的物料進行沖洗，清楚粘附在車身周圍的混凝土跟污泥，避免在空氣中迅速干燥導致影響后期沖洗。然后需要往攪拌桶中注入清水，司機將自動上料攪拌車滾筒迅速旋轉五到十分鐘然后將水排出去，以保障筒體內部的清潔。這樣一來我們二次使用自動上料攪拌車的時候就不會出現麻煩了。

After the completion of the construction, it is necessary to use the hose attached to the automatic feeding mixer to flush the residual materials on the inlet and outlet, so as to clear the concrete and sludge adhered around the body, so as to avoid the influence of rapid drying in the air on the later flushing. Then, clean water needs to be injected into the mixing bucket. The driver will quickly rotate the drum of the automatic feeding mixing truck for five to ten minutes, and then discharge the water to ensure the internal cleanness of the barrel. In this way, when we use the automatic feeding mixer for the second time, there will be no trouble.