一、攪拌車拖輪是干什么的？

1、 What does the mixer tug do?

答：攪拌車拖輪是個軸承，用這個把罐體支撐起來啊，它是與攪拌車是一體的，輔助攪拌。

A: the tug of the mixer truck is a bearing. Use this to support the tank. It is integrated with the mixer truck to assist mixing.

二、攪拌車液壓泵怎么換油？

2、 How to change the oil of hydraulic pump of mixer truck?

答：一般不建議自己換，直接到售后點找人事更換，而且使用的油必須符合要求，不然對設備損害很大，使用壽命也會大大縮短，更換合理標號的液壓油。

A: generally, it is not recommended to replace it by yourself. Go directly to the after-sales point to find someone to replace it, and the oil used must meet the requirements, otherwise it will cause great damage to the equipment and greatly shorten the service life. Replace the hydraulic oil with a reasonable label.

三、水泥攪拌車罐體填充率跟罐體的傾角有什么關系？

3、 What is the relationship between the filling rate of the cement mixer tank and the inclination of the tank?

答：目前攪拌車傾角在12度左右，填充率為63%左右。傾角不好測量，填充率也很難計算。目前銷售攪拌車都以有效攪拌容積為準。

A: at present, the inclination angle of the mixer is about 12 degrees, and the filling rate is about 63%. The inclination angle is not easy to measure, and the filling rate is also difficult to calculate. At present, the effective mixing volume is the standard for the sale of mixer trucks.

四、攪拌車罐不轉，轉開了沒力而液壓油從油箱加油口噴出來是什么原因？

4、 What's the reason why the mixer truck can't turn, and it's powerless to turn it, but the hydraulic oil sprays out from the filler of the oil tank?

答：液壓一個進一個回，進沒力可能是油泵封閉部分壞了。回油沖，可能是油泵封閉腳墊壞了，換個腳墊看看。

A: the hydraulic pressure enters and returns one by one. The lack of force may be due to the failure of the sealing part of the oil pump. The oil return flushing may be due to the damage of the sealing foot pad of the oil pump. Replace the foot pad and have a look.

五、攪拌車攪拌桶的轉速是多少？

5、 What is the rotating speed of the mixing drum of the mixing truck?

答：進料時攪拌筒的轉速：6-10轉/分；攪拌時攪拌筒的轉速：6-10轉/分。

Answer: the rotating speed of the mixing drum during feeding: 6-10 rpm; The rotating speed of the mixing drum during mixing: 6-10 rpm.

六、8-12方的攪拌車進料口到地面距離是多少？

6、 What is the distance from the feeding port of the mixer truck of 8-12 square meters to the ground?

答：一般8-12方的攪拌車整車高度大概在3.8米左右，進料口距離地面就有3.5-米左右，具體的根據(jù)不同的車型來定。

A: generally, the height of the whole 8-12 square mixer truck is about 3.8 meters, and the distance between the feed inlet and the ground is about 3.5 meters, which depends on different models.

七、水泥自動攪拌車怎么清洗罐？

7、 How to clean the tank of cement automatic mixer?

答：攪拌車配的水箱，每次卸完料后就應該將水放入罐體內，在返回時攪拌行使，到攪拌站后再將水排出接料。罐體外表應該在水箱加水時即可順便清洗。當然也可以直接用水箱內的水清洗。如果水泥漿已經凝固，罐體內找的清罐，外表凝固用草酸刷洗就行了。

Answer: the water tank equipped with the mixer truck should put the water into the tank after discharging each time, mix it when returning, and then discharge the water after arriving at the mixing station. The surface of the tank should be cleaned when the water tank is filled with water. Of course, it can also be cleaned directly with the water in the water tank. If the cement slurry has set, clean the tank inside and brush it with oxalic acid when the surface is set.

以上就是問題解答的相關內容了，希望能夠幫助到大家，如對這一問題還存在任何疑問，都歡迎關注我們網站http://www.sansungmobile.cn并咨詢我們的工作人員，將竭誠為您服務。

The above is the relevant content of the question answer. I hope it can help you. If you still have any questions about this problem, you are welcome to follow our website http://www.sansungmobile.cn And consult our staff, will serve you wholeheartedly.