對于開水泥自上料攪拌車的司機而言，可怕的情況莫過于剎車失靈了。作為基本、重要、核心的主動安全技術，剎車幾乎是汽車安全關鍵中的關鍵。試想，一部無法停下來的水泥自上料攪拌車是多么的危險。如何應對攪拌車在行駛中剎車失靈呢?以下一些經驗分享給大家。

For the driver of the cement self loading mixer, the most terrible situation is that the brake fails. As a basic, important and core active safety technology, braking is almost the key of automobile safety. Just imagine how dangerous it is for a cement self loading mixer that cannot stop. How to deal with the brake failure of the mixer truck during driving? Here are some experiences to share with you.

剎車失靈的原因：

Reasons for brake failure:

不合理的操作方法導致零件失效，攪拌車的錯誤操作導致零件失效的原因是駕駛員缺乏駕駛經驗。下長坡時，要降低車速，用發動機控制車速，盡量少用剎車，防止剎車片過熱，踩剎車時用點剎代替“一腳悶”的方法。

Unreasonable operation methods lead to the failure of parts. The reason for the failure of parts caused by the wrong operation of the mixer truck is the lack of driving experience of the driver. When going down a long slope, reduce the speed, use the engine to control the speed, and use the brake as little as possible to prevent the brake pad from overheating. When stepping on the brake, use the point brake instead of the method of "one foot is stuffy".

嚴重超載導致制動器失靈，嚴重超載，攪拌車總質量增加。在重力加速度作用下，車輛慣性增大，直接導致制動失效。超載車輛增加了車輛的總質量，從而增加了車輛的慣性。駕駛超載車輛時，我們必須減速。我們不能不考慮生命安全就匆匆忙忙。

Severe overload leads to brake failure, severe overload, and total mass of mixer truck increases. Under the action of gravity acceleration, the vehicle inertia increases, which directly leads to brake failure. Overloaded vehicles increase the total mass of the vehicle, thus increasing the inertia of the vehicle. When driving an overloaded vehicle, we must slow down. We can't rush without considering the safety of our lives.

切忌驚慌，這是正確處理好事情的前提。一旦發覺汽車剎車失靈，千萬不要驚慌失措，否則踩到了油門或者亂打方向都只能雪上加霜。正確的辦法是掌握好方向盤，不要隨意變線，密切注視周圍行車的情況，盡量保持車輛的平穩運行，當然，切忌再踩油門。

Don't panic. This is the premise of handling things properly. Once you find that the car brake fails, don't panic. Otherwise, stepping on the accelerator or hitting the direction will only make things worse. The correct way is to master the steering wheel, do not change the line at will, pay close attention to the surrounding driving conditions, and try to keep the vehicle running smoothly. Of course, do not step on the accelerator again.

然后，啟動應急燈，在保持車輛平穩運行的同時，立即啟動汽車應急雙閃功能，引起周邊行駛汽車的注意。這點非常關鍵，因為這可以明白告訴周圍的汽車，你的車處于緊急狀態，一般在這種情況下，周圍的車都會立即對你的車的行駛狀況保持警惕狀態，要么避讓，要么減速，要么繞行，總之，周圍的車的禮讓會讓你在剎車失靈的情況下容易駕駛得多，而不至于使駕駛員在應付剎車失靈的情況下還要過多的應付周圍的危險情況。

Then, start the emergency light, while maintaining the smooth operation of the vehicle, immediately start the emergency double flash function of the vehicle to attract the attention of the surrounding vehicles. This is very important because it can clearly tell the surrounding cars that your car is in an emergency. Generally, in this case, the surrounding cars will immediately keep alert to the driving conditions of your car, either avoid, slow down, or bypass. In short, the courtesy of the surrounding cars will make it much easier for you to drive when the brakes fail, So that the driver will not have to deal with the surrounding dangerous situations when dealing with brake failure.

根據經驗，我們把遇險后的動作簡單總結為以下步驟：松油門-靠邊—搶擋—拉手剎—停車。需要強調的是，為了讓車停得更快，要盡可能搶入低擋。更多相關事項就來我們網站http://www.sansungmobile.cn咨詢了解吧。

According to our experience, we can simply summarize the actions after distress as the following steps: release the accelerator - pull aside - grab the gear - pull the handbrake - stop. It should be emphasized that in order to make the car stop faster, try to enter the low gear as much as possible. For more information, please visit our website http://www.sansungmobile.cn Consult and understand.